How To Change Control Board On Maytag Washer
How To Change Control Board On Maytag Washer. In addition to a number of heat and tumbling settings, many maytag washers also have digital displays that indicate the minutes left on a washing cycle, which settings you have chosen and error messages. I dug through my stash of old caps and sure enough i had one so i removed the old one and replaced it with the one i had (notice i didn’t say new) and reinstalled the board.
Disconnect from the power source for one minute. If an error message causes your maytag washer to not run properly, reset the washer to clear the error message. Position the motor control board in the base of the washer and replace the mounting screws.
Leave The Control Panel Face Down.
Globpro w10860464 washer main control motherboard 9 length approx. If an error message causes your maytag washer to not run properly, reset the washer to clear the error message. Then, disconnect the control board from the cables and plastic tabs that keep in place, and remove the old control board from the control panel assembly.
Due To Minor Differences Among These Models, The Same Error Code Can Indicate Different Problems On Washing Machines With Differing Model Numbers.
At first glance i really didn’t see anything out of the ordinary but after a more careful inspection i found a little tiny capacitor that was popped. In addition to a number of heat and tumbling settings, many maytag washers also have digital displays that indicate the minutes left on a washing cycle, which settings you have chosen and error messages. Reconnect the air hose down to the back of the control board.
Using Your Digital Photograph Or Documentation As A Guide, Connect All.
Connect the green ground wire to the base of the washer. Pull the control board out and shift the control panel. Position the motor control board in the base of the washer and replace the mounting screws.
Also, Depress The Locking Tabs Along The Edge Of The Control Board Closest To The Curving Edge Of The Control Panel.
Connect the wires to the new motor control board. A wide range of choices for you to choose from. 5.0 out of 5 stars.
This Is A Repair Service For Any Whirlpool Duet Dryer Control Board, Oem Part Number, Wpw10256720.
Remove control panel back cover (1/4 or 5/16” hex head screws). This board can also be in kenmore and maytag dryers. The keys are sensitive, so epic washers have a button that locks the control panel to stop accidental activation of a new option during a cycle.
Post a Comment for "How To Change Control Board On Maytag Washer"