Whirlpool Duet Control Board Removal

Whirlpool Duet Control Board Removal. Remove the panel plate on the left side of the dryer as you face it by removing the screws and also. Then push any random button four times, and the whirlpool washer will go to the test mode.

I am trying to remove the control panel on a duet from www.justanswer.com

Remove the control board from the washer Then at the top there should be two 1/4 screws that hold the control panel in place, take those out and then you will need to carefully remove the ring that goes around the door. Disconnect power from the washer;

Source: www.justanswer.com

Release the two tabs on either side of the inside of the control panel. This board can also be in kenmore and maytag dryers.

Source: www.justanswer.com

Push it back until it’s as far back as it will go and the screw hole will line up. Attempt a duet washer quick diagnostic test;

Source: www.justanswer.com

If that doesn't work replace the user interface: The control board or nearby elements.

Source: www.justanswer.com

Disconnect washer from its power source. When you are ready to resume use of the washer, you must first unlock the control panel.

Source: www.justanswer.com

A burnt relay contact on the control board. Pull the control panel away from the front of the machine.

Source: www.justanswer.com

If that doesn't work replace the user interface: If the wall plug has power.

On The Control Panel Of The Duet Washer, Look For The Unlock/Control Button.

The control panel can now be completely removed from the machine. To replace whirlpool duet dryer interface control board first unplug the dryer and move it out from the wall where you can get to the back of the dryer. Remove the two screws behind the top panel and remove the top panel.

The Front Panel Removal Will Include Removing The Control Console Cover.

Make sure you turn off the water. Unplug the washer for 30 seconds to attempt to reset the duet washer control. Release the two tabs on either side of the inside of the control panel.

Konnichiwa To All My Friends And Brethren In The Craft!

When this control board failure occurs it causes the f01 code to be displayed. I have a whirlpool duet washer, model ghw9200lw ser # xxxxx the control button has pushed thru the hole, making the washer inoperable. Unplug the washer for 30 seconds to attempt to reset the duet washer control.

Disconnect And Then Reconnect The P3 And P4 Connectors On The Main Control Board.

Disconnect the control panel wire harness connected to the circuit board by lifting the tab then pulling the harness off. Disconnect the cables from the control board; When the need arises to replace the counterweights or springs on a whirlpool duet washer, the front of the washer will need to be removed.

Check Power At The Control.

The main control board is located on the left side panel near the top. Disconnect washer from its power source. Make sure the inner drum turns freely.