Goodman Furnace Control Board Fuse
Goodman Furnace Control Board Fuse. They can come loose over time due to the natural vibrations of the unit. The system has worked well in both heating and cooling modes until this winter.
The specs (pdf) are located online. Your goodman furnace isn’t getting power because of a faulty power supply, dead thermostat batteries, a faulty control board, or a blown fuse. This will occur 3 times, then will quit running.
The Heater Worked Fine During The Winter.
Goodman b1809913s control board with wire harness furnace. I did a recent service call and the 5 amp fuse in the circuit board on the furnace was blown. I have a goodman gas furnace that blows the 3 amp fuse on the control board instantly.
(Well, What Passes For Winter In Phoenix) Upon Starting The System In The Heating Mode It Ran For About 30 Minutes And Then Blew The 3A Control Fuse.
This is a split unit with a remote heat pump outside. Could this be a bad gas valve? The guy has a new condensing unit installed last year.
I Was Blowing The 5 Amp Fuse On The Control Board For My Forced Air Gas Furnace.
It has no pilot light, and the thermostat is blank. If you want to get your furnace repaired, you will likely have to call your hvac technician. He just called and told me fuse is blown again.
They Can Come Loose Over Time Due To The Natural Vibrations Of The Unit.
I have a honeywell hz322 zone controller. The common reasons behind your furnace control board no lights are blown control board fuse, faulty control board wiring, broken control board light, an insufficient supply of electricity, and insufficient gas supply. Half a minute goes by and the blower motor will come on and circulates cold air in the house.
Now The Fuse Blows Whenever A/C Or Heat Is Selected (And Temp Adjusted).
But i cannot find in the specs, online, or elsewhere on the board what the recommended(not the maximum) amp rating fuse is. (goodman aruf48d14ac air handler and vsz140421aa heat pump) on the chance it was just a bad fuse, i replaced it and it blew again after approximately 3 mins of air handler and condenser operation. Get genuine goodman factory oem circuit and control boards for your goodman unit.
Post a Comment for "Goodman Furnace Control Board Fuse"