Skip to content Skip to sidebar Skip to footer

No Control Board On Furnace

No Control Board On Furnace. Only 4 wires coming from unit. If it determines something is wrong, it shuts the furnace down to protect itself and you.

Goodman Furnace /ac No Y Terminal On Board HVAC DIY
Goodman Furnace /ac No Y Terminal On Board HVAC DIY from www.diychatroom.com

Sometimes installers do not attach the y wire to the furnace’s control board but attach it outside the furnace or near the control board. You should be able to do this by turning the power off to your furnace and disconnecting the wires that go to your blower motor from the control board. I have a bryant 310aav gas furnace and i'm trying to locate the control board.

The Ac Power Is Disconnected.


Some of the thermostat wires are spliced to split red/white wires running to the ac outside and to a condensate pump near the furnace. Take the blue wire from the cable to the thermostat, nut it with the two blue wires in the foreground, done. Egc−1 controls replaced by egc−1 the blower will operate continuously on low speed when connected to the control board as previously installed.

The Furnace Won’t Stay On.


It controls the various functions for several different brands of furnace. If there is any such wire, verify it as the common wire by examining the circuit board inside your furnace. Turn off both high voltage and low voltage power by pulling the unit’s disconnect and turning the indoor air handler off.

So I Would Wire In The Adapter For The Y, W, R, G, But I Am Not Sure How To Wire In The C.


Control looks to be 20 gauge 2 wire (red/white). Measure from r to c at the control board. I have a bryant 310aav gas furnace and i'm trying to locate the control board.

If The Igniter Fails, The Furnace’s Burners Can’t Light.


Examine circuit board of your furnace/heating system. Just switched the tstat to heat s. No control board anywhere to be found.i searched what i think was every inch of the unit.

If You Are Not Getting 24 Volts Between The Y And C (Com) Wires When The Thermostat Is Calling For Cooling To Be On Then You Must Have Either A Thermostat Problem Or A Thermostat Wire Problem.


Damage to the control board and/or blower motor may result. Is it inside that metal box at the bottom with the big yellow circle? We use cookies to give you the best possible experience on our website.

Post a Comment for "No Control Board On Furnace"