Remove Control Board Frigidaire Affinity Dryer
Remove Control Board Frigidaire Affinity Dryer. Remove top lid (2 screws in rear) remove plastic front panel (4 screws) from behind. Unplug your frigidaire dryer from the electrical outlet.
Remove the (5) screws holding the control board to The closest error to 62 is e 59, this is a tachometer problem. The light will be on knob will be on 15 minutes but the light shows 45.
On Frigidaire Affinity Dryers Or Electrolux Dryers, You May Experience Three Different Error Codes Relating To Heat Problems.
Electronic control board 134557202 manages the functions of the dryer, such as drying time and temperature. There may be a few additional components attached to the old control board; Than there are screws you can remove the control panel with under that, have you done that yet?
If The Code Appears Again After You Restore Power To The Dryer, The Electronic Control Board Will Need To Be Replaced.
Press and hold the control lock button for five seconds to release the lock. With most dryers, the rear panel will need to be removed. Remove the (5) screws holding the control board to
Answer Hoosier, You Have The Correct Control Board.
Almost immediately i need service due to the washer leaking, not filling up with water properly and the dryer would not dry the clothes completely. All click and seem to work. You can inspect these relay connection visably by removing the front control panel you might want to try setting the machine to the fluff/air dry setting and try starting the dryer, if it starts in air fluff you need to check the connections on that relay this is not a factory taught test.
Once You’ve Done So, Disconnect The Old Control Board From Its Various Electrical Connectors.
Slide a putty knife between the top panel and front panel, on the left side. 134523200 laundry dryer control board from frigidaire is a genuine oem part. To do so, you’ll have to remove the top panel of the dryer before you can remove the panel in front of the control board.
Carefully Unsnap Control Board Housing (No Longer Included W Part) In Order To Disassemble And Access Control Board.
The dryer does heat up and everything seems fine. The light will be on knob will be on 15 minutes but the light shows 45. Remove the screws that secure the back panel of the dryer.
Post a Comment for "Remove Control Board Frigidaire Affinity Dryer"